Bought as a replacement for 3 access points without roaming. With Skype and voice over WiFi, that is bad work. The access points also pushed each other away.
Seen the deco M9 at work with friends, it works fine there in difficult circumstances. My wife just didn't like it. The X60 could appeal to her.
So ordered. And started work the same evening.
First x60 point was easy to install. Then get started with points 2 and 3. These must first be activated at Max 1 meter from the first. Ideally, the system should also be in router mode. this works best.
Then you can place them wherever you want. Do you want them to communicate wirelessly with each other? Put them down according to the app's advice and you're done.
If you want to use the ethernet backhaul (like me) then you have to pay attention:
1: start the installation as recommended (install next to first deco)
2: pay attention to how your first deco works, do you also want the router functions? Then deco 2 and deco 3 can only be used on a switch that is directly on the first. Otherwise backhaul will not work
Do you only use decos as access points? Then you can just connect them however you want. They must be in 1 network
3: when connecting to the ethernet cable, the deco unit 2 and 3 gives an error message (red LED). Just wait for restart and it will fix itself
Using the decos is easy. Network is super stable. Roaming can be switched on and off per device and functions seamlessly. Old and new WiFi devices do not interfere with each other. Everything goes but the right band and speed.
Restores connections with devices and among themselves (Ethernet cable out or in, give it a moment and the relevant deco just works again)
And you can include the points in the network differently if only at least 1 is connected via a network cable.